I turn him off, then turn him back on a 2nd time and he repeats his growl along with his error code with the face senerio. gbrandwood08-12-2007, 02:22 PMWhen will Segway be releasing the known list of error codes? It beeps like one, but doesn't shut off when I step off - I have to shut it off manually. this worked for me. http://wx2me.com/error-code/segway-error-e012.php
I plugged in the charger and got one red light and after two day still got one red light and no reading on the info key. I guessing it's the Seg's way of saying that the hill is so steep that even forcing you to slow down isn't enough to prevent overcharging. Dealers with online access to the Dealer Extranet can answer questions like this, but cannot give you a print out. Sadly sometimes these things happen, but that is why having a good dealer is important to take care of these things and make them non-problems.
I get an e167 code all the time. I plan to call tomorrow. I basically washed it out to clean it up before the dealer showed up.
Tout cela se trouve ici.Où êtes vous? Freddy11-12-2006, 06:04 PMC-108 came up when Removing cord after charging and going down hill 1/4 mile, Of course the speed limiter was kicked in to keep me about 5 mph after symbol I removed and reset the batteries and the x2 worked again. Segway X2 Manual symbol which I get every time now.
I also recently went through the "E80E saga." You can read about it here (http://forums.segwaychat.com/showthread.php?t=24337&highlight=E80E). Segway Gen 1 Error Codes Anyone know what it means? If you start the Segway with one infokey, and shut it down with the second infokey, the first infokey shows this error code: E012 I stopped for coffee on the way Decode of Error code The Front CU Board reports: The temperature of the battery packs is too hot or too cold Recommended Action: Allow the battery packs to return to a
Do auto manufacturers, TV manufacturers, appliance and whitegoods manufacturers make all that sort of info available freely and publicly about their products and diagnostic tools ? Segway Error Code E407 have somebody experiences with this isue? Clear the error code as follows: Press and hold the four bottom buttons on the face of the monitor (Recall, right arrow, up arrow and OK). How could any logical decision maker at INC not be persuaded by your logic.
TIA gbrandwood11-12-2007, 05:57 PMWill has cleared up E027 error in my other thread. (http://forums.segwaychat.com/showthread.php?p=155968#post155968) Here are the details: Here is the following response for putting in that error code into the http://www.concept2.com/service/monitors/pm2plus/troubleshooting/monitor-displaying-e011-or-e012 Error code: E10A Discussed here: http://forums.segwaychat.com/showthread.php?t=13762 Meaning: Power Base failure. Segway Error Code E042 Solution: Find some power, and charge the batteries. ;) PeterS11-09-2006, 05:21 PMUPDATE: Segway replied in just one day :) Error code: E17F Discussed here: http://forums.segwaychat.com/showthread.php?t=13911 Meaning: The Front CU Board reports: Swagway Error Codes Cheers Michael www.segwaysoutherncross.com Australia terryp08-02-2008, 06:41 PMc200 = The Rear CU Board reports: The temperature of the battery packs is too hot or too cold Recommended Action: Allow the battery packs
Prior to this several weeks ago it displayed a red light on one of the charge indicators, which followed the battery when swapped. http://wx2me.com/error-code/segway-error-code.php ran fine after it shutdown. We only deal with the proper segway brand. Every block I tried again, and on the 3rd try the error code changed to E407. Segway Error Code E10a
Just remember that an x2 and i2 ride differently, where the i2 will go fast up or down hills, the x2 is more cautious about it. I believe that vehicle sensing systems at intersections use low frequency RF applied to loop coils. I walked out of range and back again and pressing the info key power button gave me a normal shut down and the fault cleared. click site Any ideas?
Thanks for the help. Swegway Faults I was and have since switched to a new pair. Can't even get a parts book or service manual...
Then there is something else that Myles does and he has down this twice now The battert icon shows up when I have him fully charged and he is smiling. Isidore01-30-2009, 06:27 PMError code: eb90 The Training Safety Shutdown was activated or Error code: EB 90 The Rear CU Board reports:
Copyright © 1984-2014 JK Products &Services Designed by AceOne ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.10/ Connection I don't know whether the replacement is AF or not yet. Wheels continued to spin for a second until C040 and power down. navigate to this website When I went to leave, I found the Seg powered down - as expected, but the infokey was still turned on, with an E012 error code.
ru12cb404-20-2008, 10:11 PMWhat's the deal if you get no reading on you Info key on X2's? What is the industry norm ?